Strongest Drylining Dot and Dab Hollow Wall Fixings


“Now Corefix has provided the answer it is likely to be the go to product for this type of application. At present there is nothing I know of that will match it.”
Roger Bisby - Professional Builder Magazine

This article was recently published in the Professional Builder Magazine.

Roger Bisby is a UK based television presenter and journalist, well known for his expertise in the building industry.

Best Drylining Dot and Dab Hollow Wall Fixings

Corefix is a dry lining and dot and dab fixing capable of supporting a 90kg load*.

Dot and dab is so common these days that there ought to be any number of specialist fixings solutions out there but you don’t see them.

Even extra-long wall plugs would be a help but they are hard to come by unless you go to a specialist fixings centre.

If you need to hang something heavy, such as kitchen wall units, or a radiator on a dot and dab or dry lined wall, you have to get a good fixing into the masonry, and that leaves you with a screw that is hovering in free space behind and through the plasterboard. It is very far from ideal.


Purposely made for dry lining and dot and dab fixings

The Corefix system from Metex is a purpose-made fixing for dry lining and dot and dab. It provides a very stable fixing because the steel core or sleeve fits deep inside the plastic wall plug with an interference fit and bridges the gap behind the board to sit snugly in the plasterboard face ready to receive the screw.

Not only do you get a rock solid fixing it also doesn’t pull the plasterboard in or cause the screw to bend.

The safe working load will depend as much on the host material as the fixing, but provided the weight is predominantly straight down rather than a cantilever, using four Corefix fixings will give you a 90kg SWL which is more than ample for the largest wall hung radiators and kitchen units.

Certainly it would take a big television. The plastic wall plug has some very chunky ribs which will lock nicely into aircrete block as well as harder materials.

If you think about how much dot and dab plasterboard is out there it is nothing short of astounding that the major fixings companies have largely ignored this specific task, and left builders to come up with their own bodges. Far too many of them have assumed that getting a fixing into the plasterboard will be enough but they have not thought it through.

Now Corefix has provided the answer it is likely to be the go to product for this type of application. At present there is nothing I know of that will match it.

Corefix for secure dot and dab wall fixings
You will need a 10mm drill bit. If you are going into aircrete block you won’t need the hammer action.

Corefix for secure hollow wall fixings
Drill the hole deep enough to take the plug so it is flush with the face of the board.

Corefix for secure dot and dab wall fixings
Tap the plug in and then tap the steel core in until it is flush.

Corefix for secure hollow wall fixings
Use the screws provided to make your fixings.

Corefix for secure plasterboard wall fixings
Four fixings will give you a 90kg safe working load.

*Corefix has been in-house tested to over 250kg without failure. Corefix has been independently tested to a safe working load of 90kg based on 4 x Corefix fixings.

Just click the following link to view a short video of how to use the best hollow wall anchors

If you have any questions at all please contact us directly. We would be delighted to hear from you.